TheAlarmTech.com

See Attachment. Est tech note for cable

Another FW 1.5 Advantage--- In previous FW versions, Any time the End User would attempt to ENABLE an input on FW, a "Warning" box would pop up."WARNING..Did you hit reset, and this zone could go into alarm." Now...The Warning box ONLY pops up if the input is in alarm. If the zon...

I had an Issue with a 3-PPS Pwr Supply whereas I would get a Battery Trouble Swinging but the Batts were Good.
See Enclosed Tech note. There is a Firmware issue with the 3-PPS when you have Rev 3.6 Firmware. I thought I would post helpful info..

I installed Fireworks Version 1.5. Good Stuff--- 1-) When you back up your database in System Builder, It provides a Check box to give you the option to Do a "Full" Backup. This auto backs up Maps,Database,icons, etc..(Before you could only back up the actual database) 2-) 1.5 gives the en...

Fireworks V1.5 upgrade. There is a documented issue with running Sensitivity report for Signature Loop Controller with an Analog controller in the same cabinet. This may be related with running a Analog Loop controller sensitivity report with a Signature Loop controller in the same cabinet. The repo...

You dont have to use an RJ-11 Cable all the time if You dont want to...Sometimes, I go to a site, Use my Rj-11 to Initially load, then leave a 9 pin connector/wire on site. 1-) I have an rs-232 card in my truck. (If you dont have one or an 232 card installed on the panel you need to load, you cant u...

When you see all the Leds flashing or pulsating, that is an indicator that it is in "Comm Fail" Hence... The " 01070601 Rail Module Communication Fault" you are getting.. -- Make sure you have the Cables on correctly between your Chassis. (and seated firmly) -- Look at your SDU p...

To be able to Program the Est-3 and Fireworks Systems, you need to be factory certified by EST. Once you successfully pass a battery of written tests while attending the 2 week "Boot camp" course in Sarasota,Florida you are also given a "Programming Dongle" This Dongle is connect...

What "Pseudo zones" is the panel showing? is the panel 100% clear and just wont map? Can you upload a map from card? See info below.. Mapping Error 1. A discrepancy between the internal map and the devices installed on the Data Circuit (serial #, personality code, or device type) 2. Device...

In the past I have had a similar issue. Ie- multiple Alarms on same SSDC card at same time. Almost like the Card "Crashed". After looking into several different possibilities, I found that my SSDC card had too many devices on card. Detectors are usually not the issue. Modules are usually t...